How To Maintain A Chain Saw Bar
by staff on March 3, 2010
1st issue you do is remove bar through the powerhead and chain. Following lightly really feel along the edge in the bar you must observe a sort of wire edge this wants to go(they’re commonly extremely sharp so use caution). Take your flat file and file together the bar as within the image. The thought is always to get rid of the wire edge so the bar features a smooth surface
The following stage is to clean the groove. It is possible to use anything that may fit within the groove. I use a broken piece of hacksaw blade with a single end taped for the handle.
The last stage is tighten up the bar rails. To try and do this you’ll need a rail better. Just stick to the directions that arrive along with your closer. I look at the rail nearer just s essential being a chain file.
1st issue you do is remove bar through the powerhead and chain. Following lightly really feel along the edge in the bar you must observe a sort of wire edge this wants to go(they’re commonly extremely sharp so use caution). Take your flat file and file together the bar as within the image. The thought is always to get rid of the wire edge so the bar features a smooth surface
The following stage is to clean the groove. It is possible to use anything that may fit within the groove. I use a broken piece of hacksaw blade with a single end taped for the handle.
The last stage is tighten up the bar rails. To try and do this you’ll need a rail better. Just stick to the directions that arrive along with your closer. I look at the rail nearer just s essential being a chain file.
Tagged as:
chain saw bar